Regal V6-3.8L VIN K (1997)
-
Brake fluid level in reservoir and fill to the correct level if necessary.
22. Install brake fluid reservoir cover.
23. Turn the ignition switch to the "RUN" position, turn engine off. Apply brake pedal with moderate force and hold. Note pedal travel and feel.
-
If pedal feels firm and constant and pedal travel is not excessive, start the engine. With the engine running, recheck the pedal travel. If it's still
firm and constant and pedal travel is not excessive, go to Step 22.
-
If pedal feels soft or has excessive travel either initially or after engine start, the following procedure may be used. With the scan tool, Release
then Apply each motor 2 to 3 times and cycle each solenoid 5 to 10 times. When finished, be sure to Apply the front and rear motors to ensure
the pistons are in the up-most position. DO NOT DRIVE THE VEHICLE. If a scan tool is not available, remove foot from brake pedal, start
the engine and allow it to run for at least 10 seconds to initialize the ABS. DO NOT DRIVE THE VEHICLE. After 10 seconds, turn the
ignition off. This initialization procedure MUST be repeated 5 times to ensure any trapped air has been dislodged. Now repeat bleeding
procedure starting at Step 1.
24. Road test the vehicle.
-
Make several normal (non-ABS) stops from a moderate speed to ensure proper brake system function.
