Regal V6-3.8L VIN K (1997)
2. Install the right (rear) exhaust manifold bolts and nuts. Tighten the right (rear) exhaust manifold bolts and nuts to 30 Nm (22 ft. lbs.).
3. Install the lower right (rear) exhaust manifold heat shield.
4. Install the upper right (rear) exhaust manifold heat shield.
5. Install the fuel injector sight shield bracket.
6. Install the fuel injector sight shield bracket nuts. Tighten the fuel injector sight shield bracket nuts to 30 Nm (22 ft. lbs.).
7. Install the right (rear) engine lift bracket.
8. Install the right (rear) engine lift bracket bolt and nut. Tighten the right (rear) engine lift bracket bolt and nut to 30 Nm (22 ft. lbs.).
9. Install the right (rear) spark plug wires. See Powertrain Management.
10. Install the wiring harness and the heater hose retaining clips to the fuel injector sight shield bracket.
11. Install the three way catalytic converter pipe to the right (rear) exhaust manifold. See Powertrain Management.
12. Install the EGR adapter pipe to the right (rear) exhaust manifold. See Powertrain Management.
13. Lower the vehicle.
14. Install the exhaust crossover pipe to the right (rear) exhaust manifold.
15. Install the fuel injector sight shield. Refer to Engine Cover Replacement See: Engine/Service and Repair.
16. Connect the battery ground (negative) cable.
