Regal V6-3.8L VIN K (1997)
PROM - Programmable Read Only Memory: Customer Interest
PROM - Starter Motor Cranks Right After PCM is Replaced
File In Section: 6E - Engine Fuel & Emission
Bulletin No.: 77-65-21
Date: October, 1997
Subject:
Starter Motor Cranks Immediately After Key On When PCM is Replaced
(Use Updated PCM Calibration)
Models:
1997 Buick Century and Regal
with 3.1 L, 3.8L Engine
(VINs M, K, 1 RPOs L82, L36, L67)
Condition
Starter motor begins cranking immediately after key on when technician replaces PCM (Powertrain Control Module).
Cause
Internal to some service PCMs.
Correction
To avoid the condition use only the updated service PCM as listed In the Parts section of this bulletin. Program the service PCM with calibration
obtained from the most current CD from GM Service Technology Group (STG).
Important:
Do not attempt to order calibrations from GMSPO. The calibrations are programmed into the vehicle's PCM via a Techline Tool Device.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation
Description
Time
J6360
Controller, PCM/VCM -
Use Published
Replace & Reprogram
Labor Operation Time