Regal V6-3.8L VIN K (1997)
Body Control Module: Service and Repair
BCM Setup/Reprogramming Procedure
Direct Programming
1. Select SERVICE PROGRAMMING SYSTEM from Techline Navigator or by selecting F2 on the Information Menu.
2. Select SPS/EEPROM on the Diagnostic Menu.
3. Select TERMINAL TO VEHICLE for the Programming Method.
4. Select NEW VEHICLE and follow screen instructions.
5. Connect Data Link Connector (DLC) cable to the vehicle.
6. Turn the ignition switch to the RUN position.
7. Select OK. The Vehicle Identification Number (VIN) will be read. If VIN cannot be read, VIN will need to be entered.
8. Select SPECIAL.
9. Select PROGRAM BY VCI.
10. Enter 1008 for VCI number and select DONE.
11. Verify that the DLC cable is connected to vehicle and verify ignition switch is in the RUN position.
12. Summary of selected calibrations is displayed with Body Control Module (BCM) calibrations. Make sure to select correct calibration based on
vehicle features.
13. Select PROGRAM.
14. Select YES to confirm programming.
Indirect Programming
1. Connect a Tech 2 scan tool to the vehicle Data Link Connector (DLC).
2. Select VEHICLE YEAR and TYPE.
3. Select REQUEST INFORMATION soft key.
4. Connect Tech 2 scan tool to terminal.
5. Select SERVICE PROGRAMMING SYSTEM from the Techline Navigator or by selecting F2 on the Information Menu.
6. Select SPS/EEPROM on the Diagnostic Menu.
7. Select NEW VEHICLE.
8. Vehicle Identification Number (VIN) will be read, if VIN cannot be read, the VIN will need to be entered manually.
9. Select SPECIAL.
10. Select PROGRAM BY VCI.
11. Enter 1008 for VCI number.
12. Select DONE.
13. Summary of selected calibrations is displayed with Body Control Module (BCM) calibrations. Make sure to select correct calibration based on
vehicle features.
14. Select PROGRAM.
15. Select YES to confirm programming. Calibration is downloaded to the Tech 2 scan tool.
16. Connect Tech 2 scan tool to the vehicle DLC.
17. Select VEHICLE YEAR and TYPE.
18. VIN and end model part number displayed on Tech 2 scan tool.
19. Select PROGRAM soft key to setup/program the BCM.
