Regal V6-3100 3.1L VIN M SFI (1996)
13. Serpentine drive belt shield.
14. Coolant recovery reservoir.
15. Raise and suitably support vehicle.
16. Support drivetrain and front suspension frame with floor stands.
17. Remove rear drivetrain and front suspension frame bolts/screws.
18. Lower drivetrain and front suspension frame.
19. Oil pan. Refer to "Oil Pan."
20. Transaxle mount to oil pan.
21. Starter motor.
22. Flywheel inspection cover.
23. Engine mount. Refer to "Engine Mount."
24. Raise drivetrain and front suspension frame.
25. Rear drivetrain and front suspension frame bolts/screws.
26. Engine mount frame side nuts to drivetrain and front suspension frame. Refer to "Engine Mount."
27. Remove floor stands from drivetrain and front suspension frame.
28. Crankshaft balancer. Refer to "Crankshaft Balancer."
29. Engine splash shield.
30. Intermediate steering shaft bolt/screw and cover.
31. Front exhaust manifold pipe.
32. Lower vehicle.
33. Remove J 28467-A and J 36462.
34. Electric engine coolant fan.
35. Engine mount strut and air conditioning compressor bracket and engine mount strut bracket.
36. Hood panel.
37. Serpentine drive belt. Refer to "Serpentine Drive Belt."
38. Add engine oil.
39. Refill with engine coolant and add two quarts engine coolant sealant pellets, GM P/N 3634621, or equivalent.
40. Bleed engine coolant system.
