Rendezvous V6-3.5L (2007)
1. Remove any dirt, grease, and other contaminants from the mounting surface.
2. Install the SDM (2) horizontally to the vehicle.
3. Point the arrow on the SDM toward the front of the vehicle.
Notice: Refer to Fastener Notice.
4. Install the SDM mounting fasteners (1).
Tighten the fasteners to 10 N.m (89 lb in).
5. Install the SDM wiring harness connector (2) to the SDM (1).
6. Install the CPA (3) to the SDM wiring harness connector (2).
7. Place the carpet to cover the SDM. Install the carpet retainer.
8. Install the right side insulator panel.
9. Install the right side cowl trim panel.
10. Install the passenger front seat.
11. Enable the SIR system. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service
and Repair
Important: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part
number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check
and follow the steps thoroughly to ensure that the SDM is set properly.
12. Reprogram the BCM.
13. Refer to Programming and Relearning See: Testing and Inspection/Programming and Relearning