Rendezvous AWD V6-3.4L VIN E (2005)
Solar Sensor: Service and Repair
SUN LOAD SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the windshield garnish molding.
2. Lift the I/P upper trim panel up approximately 51 mm (2 in) and pull rearward to release I/P upper trim panel retainers.
IMPORTANT: Remove the I/P upper trim panel slowly, the retainer clips could possibly fall into the I/P.
3. Lift the I/P upper trim panel to access sun load sensor.
4. Disconnect the sunload sensor electrical connector.
5. Remove the sun load sensor.
INSTALLATION PROCEDURE
1. Install sun load sensor.
2. Connect the sunload sensor electrical connector.
3. Align the I/P upper trim locating pins and the retainers to the slots in the I/P.
4. Push forward and down on the I/P upper trim panel to lock into place.
5. Install the windshield garnish molding.
