Rendezvous AWD V6-3.4L VIN E (2005)
Fog/Driving Lamp Switch: Service and Repair
FOG LAMP SWITCH REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) cluster trim plate bezel.
2. Grasp the fog lamp switch and pull firmly to release the retaining tabs from the I/P carrier.
3. Disconnect the electrical connector from the fog lamp switch.
4. Remove the fog lamp switch.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the fog lamp switch.
2. Position the fog lamp switch to the retainers in the I/P carrier.
3. Install the fog lamp switch to the I/P carrier. Press the switch into place until fully seated.
4. Install the I/P cluster trim plate bezel.