Rendezvous AWD V6-3.4L VIN E (2005)
Throttle Cable/Linkage: Service and Repair
Accelerator Controls Cable
ACCELERATOR CONTROLS CABLE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the accelerator cable shield, if equipped.
2. Disconnect the accelerator cable from the throttle body lever.
3. Disconnect the accelerator cable from the accelerator cable bracket.
4. Remove the left instrument panel sound insulator.
5. Disconnect the accelerator cable from the accelerator pedal.
6. Squeeze the accelerator cable cover tangs and push the accelerator cable through the bulkhead.
7. Remove the accelerator cable from the vehicle. Note the cable routing for aid in installation.
INSTALLATION PROCEDURE
1. Install the accelerator cable into the vehicle using the routing noted during removal.
NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be
securely fastened. This is necessary in order to prevent possible interference and damage to the component.