Rendezvous AWD V6-3.4L VIN E (2005)
Suspension Strut / Shock Absorber: Service and Repair
Shock Absorber - Replacement
Shock Absorber Replacement (Front Wheel Drive)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Use a utility stand in order to slightly compress the coil spring and relieve the tension on the shock absorber.
3. If the vehicle is equipped with automatic level control, disconnect the air tube connector from the shock absorber.
4. Remove the shock absorber upper bolt and nut.
5. Remove the shock absorber lower bolt and nut.
6. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber.
2.
Notice: Refer to Fastener Notice in Service Precautions.
Install the shock absorber bolts and nuts.
Tighten the shock absorber nuts to 85 Nm (63 ft. lbs.).
3. If the vehicle is equipped with automatic level control, install the air tube connector to the shock absorber.
4. Remove the utility stand from the rear axle.
5. Lower the vehicle.