Rendezvous AWD V6-3.5L VIN L (2006)
Rear Wheel Speed Sensors
1. Connect the rear wheel speed sensor jumper harness connector (1) to the wheel speed sensor, located next to the rear strut (2).
2. Install the rear wheel speed jumper harness (1) into the retaining clips (2).
3. Connect the rear wheel speed sensor jumper harness connector to the pass thru connector.
4. Lower the vehicle.
5. Turn the ignition switch to the RUN position, with the engine off.
6. Perform the diagnostic system check. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures