Rendezvous AWD V6-3.6L VIN 7 (2004)
1. Apply engine coolant to the bypass pipe seal in order to ease installation.
2. Install the thermostat bypass pipe.
3. Install the thermostat bypass pipe hose.
4. Install the thermostat bypass pipe hose clamp (5).
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the thermostat bypass pipe bolt (4).
Tighten the thermostat bypass pipe bolt to 11 Nm (98 inch lbs.).
6. Install the thermostat bypass pipe to cylinder head nut (3).
Tighten the thermostat bypass pipe nut to 25 Nm (18 ft. lbs.).
7. Install the thermostat bypass pipe to throttle body hose clamps (1).
8. Install the thermostat bypass pipe to throttle body nut.
Tighten the thermostat bypass pipe nut to 25 Nm (18 ft. lbs.).
9. Install the heater hose to the bypass pipe.
10. Install the left engine mount strut to the engine.
11. Install the upper radiator hose to the engine.
12. Install the air inlet duct.
13. Install the spark plug wire harness to the thermostat bypass pipe.
14. Fill the cooling system.