Rendezvous AWD V6-3.6L VIN 7 (2004)
2. Connect the electrical connectors to the module.
3. Connect the cell antenna coaxial cable to the VCIM.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the screws that secure the bracket to the instrument panel brace.
Tighten
Tighten the screws to 10 N.m (89 lb in).
5. Install the I/P compartment.
6. Install the right insulator panel.
IMPORTANT: After replacing the vehicle communication interface module, you must reconfigure the OnStar(R) system. Failure to reconfigure the
system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this
version of the OnStar(R) system. This action will cause a DTC to set.
7. Reconfigure the OnStar(R) system. Refer to OnStar(R) Reconfiguration. See: Testing and Inspection/Programming and Relearning
