Rendezvous AWD V6-3.6L VIN 7 (2004)
7. Separate the EBCM from the BPMV by gently pulling apart until separated (1).
Installation Procedure
1. Important: Use only new wave springs and screws supplied with the new EBCM.
Clean the BPMV surface with alcohol using a clean rag.
2. Install the EBCM (1) to the BPMV.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the 6 screws that attaches the EBCM to BPMV.
^
Tighten the top 4 mounting screws to 5 Nm (44 inch lbs.). Tighten screws in an X pattern.
^
Tighten the bottom 2 mounting screws to 5 Nm (44 inch lbs.).
^
Connect the pump motor connector to the bottom of the EBCM.
4. Connect the EBCM harness connector and depress the locking tab (1) to secure.
5. Install the air cleaner housing.
6. Turn the ignition switch to the RUN position, do not start engine.
7. Perform the Diagnostic System Check - ABS.
