Rendezvous AWD V6-3.6L VIN 7 (2004)
Tighten the fasteners to 10 N.m (89 lb in).
5. Install the SDM wiring harness connector (2) to the SDM (1).
6. Install the CPA (3) to the SDM wiring harness connector (2).
7. Place the carpet to cover the SDM. Install the carpet retainer.
8. Install the right side insulator panel.
9. Install the right side cowl trim panel.
10. Install the passenger front seat.
11. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9.
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly.
12. Reprogram the BCM. See: Testing and Inspection/Programming and Relearning
