Rendezvous FWD V6-3.4L VIN E (2005)
Rear Wheel Speed Sensors
1. Connect the rear wheel speed sensor jumper harness connector (1) to the wheel speed sensor, located next to the rear strut (2).
2. Install the rear wheel speed jumper harness (1) into the retaining clips (2).
3. Connect the rear wheel speed sensor jumper harness connector to the pass thru connector.
4. Lower the vehicle.
5. Turn the ignition switch to the RUN position, with the engine off.
6. Perform the diagnostic system check. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check - Vehicle
