Rendezvous FWD V6-3.4L VIN E (2005)
Memory Positioning Module: Service and Repair
Memory Seat Control Module Replacement
MEMORY SEAT CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disable the SIR. Refer to SIR Disabling and Enabling Zone 7 in Restraint Systems.
CAUTION: Refer to SIR Caution in Service Precautions.
2. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly.
3. Remove the fasteners.
4. Adjust the front seat assembly to the rear of the vehicle.
5. Angle the front seat cushion (1) up, in order to access the assembly fasteners (2).
6. Remove the fasteners.
7. Lift the front seat cushion assembly (1) away from the seat riser.
8. Disconnect the electrical connector.
9. Using a flat-bladed tool, release the module from the bracket.
10. Remove the memory seat module from the seat frame.
INSTALLATION PROCEDURE
1. Install the memory seat module to the seat frame.