Rendezvous FWD V6-3.5L VIN L (2006)
INSTALLATION PROCEDURE
1. Paint the new rear object sensor. Refer to Basecoat/Clearcoat Paint Systems in Paints/Coatings.
IMPORTANT: Do not refinish previously painted sensors.
2. Check the paint thickness to ensure it does not exceed 6 mils using a paint thickness gage suitable for non-ferrous metals. Refer to Paint Gages in
Paints/Coatings.
3. Align the keyhole (2) with the key (1) and press the rear object sensor bezel flush to the fascia.
4. Install the housing to the cutouts on the bezel through the back side of the fascia.
5. Install the spring (1) to the housing (2).
IMPORTANT: The spring keys must be on the top and bottom of the housing.
6. Install the decoupling ring (2) to the sensor (1).
7. Insert the sensor into the housing (4) with the connector pointing toward the passenger side of the fascia. Press the sensor tabs into the cutouts on
the housing (4).