Rendezvous FWD V6-3.5L VIN L (2006)
5. Pull the upper edge of the rear quarter panel molding out, to release the retainers.
6. Remove the rear quarter panel molding from the door.
7. Remove the push-in retainer nuts from the D-pillar, if required.
8. Remove all adhesive from the rear door body panel using 3M(TM) ScotchBrite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
9. Clean the rear door panel surface using Varnish Makers and Painters (VMP) naphtha and allow to air dry.
Installation Procedure
1. Install the push-in retainer nuts to the D-pillar, if required.