Rendezvous FWD V6-3.5L VIN L (2006)
Sunroof / Moonroof Motor: Service and Repair
SUNROOF MOTOR/ACTUATOR REPLACEMENT (PES)
TOOLS REQUIRED
J 41718 Sunroof Timing Pins
REMOVAL PROCEDURE
1. Position the sunroof window panel to the fully closed position.
IMPORTANT: This sunroof system is timed from the factory in order to allow the actuator to shut off automatically when the sunroof window
reaches a certain position. Use extreme care when removing the sunroof actuator from the sunroof module. Improper removal may cause the timing to
be thrown off. Anytime the sunroof actuator requires removal from the sunroof module, ensure that the sunroof window is in the fully closed position
and the sunroof timing pins are installed.
2. Remove the headliner.
3. Remove the right and left front screw from the sunroof window panel.
4. Install J 41718 into the front sunroof window panel screw hole in order to retain the cable adjustment.
IMPORTANT: Before removing the sunroof actuator, ensure that J 41718 are tight and holding the cable.
5. Disconnect the electrical connector from the sunroof module actuator.
6. Remove the bolts from the sunroof actuator.
