Rendezvous FWD V6-3.5L VIN L (2006)
1. If the exhaust manifold was replaced, install the following components:
^
EGR valve pipe
^
HO2S
2. Raise and support the vehicle.
3. Install a NEW exhaust manifold gasket onto the studs.
4. Install the exhaust manifold.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the exhaust manifold nuts.
Tighten the nuts to 16 Nm (12 ft. lbs.).
6. Position the exhaust manifold upper heat shield and install the bolts finger tight.
7. Position the exhaust manifold lower heat shield and install the bolts finger tight.
8. Tighten the exhaust manifold upper and lower heat shield bolts.
Tighten the bolts to 10 Nm (89 inch lbs.).