Rendezvous FWD V6-3.5L VIN L (2006)
Tighten the screws to 1.6 N.m (14 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the air temperature actuator electrical connector.
4. Install the temperature door lever (1) to the temperature door.
IMPORTANT: Align the pin on the air temperature actuator with the slot in the temperature door lever.
5. Connect the temperature door lever spring (2) to the temperature door lever (1) and HVAC module case.
6. Install the temperature door lever bolt (3) to the HVAC module case.
Tighten the bolt to 0.9 N.m (8 lb in).
7. Install the knee bolster.
8. Recalibrate the actuators. Refer to Re-Calibrating Actuators.