buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Relays and Modules - Body and Frame > < All Other Service Bulletins for Relay Module:|936E3|Page 68
Page 1
background image

Idle Speed/Throttle Actuator - Electronic: All Technical Service Bulletins
Engine Controls - Shorted IAC Motors & Poor Driveability

Bulletin       

89-6E-10

Date            

May, '89

Ref. No.       

89-106-6E

Corp. Ref. No.  916505R

SUBJECT:

IDLE AIR CONTROL (IAC) MOTORS CAUSING POOR DRIVEABILITY

MODELS AFFECTED: SOME 1988 AND 1989 SKYLARKS, CENTURYS, LESABRES, ELECTRAS RIVIERAS & REATTAS EQUIPPED WITH

3300 OR 3800 ENGINES (VIN CODES N AND C)

We have recently seen a few cases of internally shorted Idle Air Control Motor terminals on 1988 and 1989 models equipped with 3800 engines, and
1989 models equipped with 3300 engines, which may exhibit one or more of a variety of poor driveability conditions. Some of those conditions could
include:

1.

Engine miss at idle or rough idle (engine can be hot or cold).

2.

Engine miss under light acceleration.

3.

General engine roughness at all engine speeds.

4.

Cycling whine (generator) accompanied by fluctuating RPM at idle (3 or 4 times at each stop).

5.

Chuggle feel at approximately 45 mph.

6.

Excessive rattle noise from EGR valve (some noise is normal).

7.

Transmission complaints about 3-4 shifts (rough, or repetitive 4th gear engagements).

8.

Comments about T.C.C. operation (rough, shudder).

It should be noted that each vehicle may exhibit different symptoms and these sometimes can be intermittent. Although this problem is not very wide
spread, it can be very difficult to diagnose unless the following procedure is used, since an IAC motor is not generally associated with these types of
comments.

A quick test of the IAC motor can be performed by simply disconnecting the harness connector at the IAC motor and determining if the poor driveability
condition is eliminated or not. The harness should be disconnected with the engine running and the IAC motor counts stabilized.

If the symptoms are still present with the IAC motor disconnected, do not replace the IAC motor. At this point, it will be necessary to reconnect the IAC
motor and refer to the appropriate Buick Chassis Service Manual for further diagnostics.

Relays and Modules - Body and Frame > < All Other Service Bulletins for Relay Module:|936E3|Page 68