buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

77-61-16A|Page 3110 > < Component Locations|Page 3103
Page 1
background image

Crankshaft Main Bearing Seal: Customer Interest
Engine - Oil Leak at Rear of Engine Near Flywheel Cover

File In Section: 6 - Engine

Bulletin No.: 77-61-16A

Date: September, 1997

Subject: 
Engine Oil Leak at Rear of Engine Near Flywheel Cover
(Replace Crankshaft Rear Oil Seal Housing Gasket)

Models: 
1995-97 Buick Park Avenue, Riviera (VIN K)
1996-97 Buick LeSabre, Regal (VIN K) 
1996-97 Buick Park Avenue, Riviera (VIN 1) 
1997 Buick Regal (VIN 1)
1995-97 Chevrolet Camaro (VIN K)
1995-96 Oldsmobile Ninety Eight (VIN K)
1995-97 Oldsmobile Eighty Eight, LSS (VIN K)
1996-97 Oldsmobile LSS (VIN 1) 
1997 Oldsmobile Regency (VIN K)
1995-97 Pontiac Bonneville, Firebird (VIN K)
1996-97 Pontiac Grand Prix (VIN K)
1996-97 Pontiac Bonneville (VIN 1) 
1997 Pontiac Grand Prix (VIN 1) with 3800 Engine (VIN 1, K - RPO L67, L36)

This bulletin is being revised to correct the File In Section. Please discard Corporate Bulletin Number 77-61-16. 

Condition

Some owners may comment about an engine oil leak that appears to originate toward the driver's side of the vehicle; rear of engine.

Cause

The crankshaft rear oil seal housing gasket may be split.

Correction

Diagnostics

1.

Install oil dye into the crankcase and warm the engine up to operating temperature by driving the vehicle a few miles.

2.

Raise the vehicle on a hoist with the engine running and inspect for oil leaks by using a black light.

3.

Shut the engine off and remove the flywheel inspection cover.

4.

Use the black light to check for oil leaks in the flywheel area. A leak in this area may be due to a split gasket on the crankshaft rear oil seal
housing.

If the leak appears to originate in the flywheel area, then remove the crankshaft rear oil seal housing and install a new gasket and a new crankshaft rear
oil seal. Follow the procedure outlined in the Service Manual.

Important

Do Not Use Any Type of Adhesive on the Housing Gasket when Reinstalling. The plastic inserts in the housing are a manufacturing assembly aid
and are not required for service.

Parts Information

Parts are currently available from GMSPO.

Description

P/N

Fluorescent Tracer Dye, Gas 
Engine Oil (1oz.)

12345795

77-61-16A|Page 3110 > < Component Locations|Page 3103