Riviera V6-3.8L SC VIN 1 (1995)
11.
Drill two 6 mm (1/4 in) holes (3) into the top surface of the LH engine frame crossmember. Both holes are to be approximately 35 mm (1.5 in)
rearward from the front and rear control arm brackets horizontal flange edge.
12.
Remove the two rosebud clips from the new hose assembly (4).
13.
Install the two rosebud clips into the holes drilled.
14.
Install the new LH routed power steering return/outlet hose assembly (1):
^
From the forward side of the front engine mount, route the pump end of the hose assembly to the RH side of the vehicle, along the RH engine
frame crossmember and up to the steering pump assembly.
^
Route the steering gear end of the hose assembly to the LH side of the vehicle, along the LH engine frame crossmember and up to the steering
gear assembly.
15.
Install the power steering pressure/inlet hose assembly (2) to the vehicle.
16.
Connect the power steering pressure and return hoses to the power steering pump assembly.
17.
Connect the power steering pressure and return hoses to the power steering gear assembly.
Tighten
Tighten the power steering pressure and return hoses to the steering gear to 27 Nm (20 lb ft).
18.
Install the bolt/screws to the retaining clips (5).
Tighten
Tighten the retaining clip bolt/screws to 6 Nm (53 lb in).
19.
Install the power steering gear assembly heat shield.
20.
Install the lower radiator air deflector (engine splash shield).
21.
Install the LH lower splash shield.
22.
Install the LH front wheel/tire assembly.
23.
Lower the vehicle.
24.
Fill and bleed the power steering system, using J 43485.
Refer to Corporate Bulletin Number 83-32~09, dated November, 1998.
