buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Driver's Inflator Module|Page 11126 > < Component Locations|Page 11123
Page 1
background image

Air Bag: Service and Repair
Driver's Inflator Module

WARNING: The diagnostic energy reserve module or sensing and diagnostic module (DERM/SDM) can maintain enough voltage to cause 
air bag deployment for up to two minutes after the ignition switch is turned off and the battery is disconnected. Servicing the SIR system
during this period may result in accidental deployment and personal injury.

1. Disarm system as described in Air Bag System Disarming & Arming.
2. Remove module attaching bolts from rear of steering wheel.
3. Rotate horn lead 1/4 turn and disconnect.
4. Disconnect inflator module electrical connector, then remove module from steering wheel.
5. Reverse procedure to install, noting the following:

a. After completing installation, rearm system as described in Air Bag System Disarming & Arming.
b. Turn ignition switch to On position and verify that the Air Bag or SIR warning lamp flashes seven to nine times and then turns off. If lamp

does not respond as specified, refer to System Diagnosis

Driver's Inflator Module|Page 11126 > < Component Locations|Page 11123