Riviera V6-3.8L SC VIN 1 (1995)
Knock Sensor: Service and Repair
Knock Sensor
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Knock sensor wiring harness connector from knock sensor.
3. Knock sensor from engine block.
INSTALL OR CONNECT
NOTE: Do Not apply thread sealant to sensor threads. Sensor is coated at factory and applying additional sealant will affect the sensors ability to
detect detonation.
1. Knock sensor into engine block. Be sure threads are clean.
Tighten
Sensor to 19 Nm (14 lb. ft.).
CAUTION: Overtorquing can damage knock sensor.
2. Knock sensor wiring harness connector to the knock sensor.
3. Negative battery cable.