buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Dual Pole Arming Sensor|Page 2126 > < Dual Pole Arming Sensor
Page 1
background image

Discriminating Sensors and Arming Sensors: Service and Repair
Forward Discriminating Sensor

WARNING: The diagnostic energy reserve module or sensing and diagnostic module (DERM/SDM) can maintain enough voltage to cause
air bag deployment for up to two minutes after the ignition switch is turned off and the battery is disconnected. Servicing the SIR system
during this period may result in accidental deployment and personal injury.

1. Disarm system as described in Air Bag System Disarming & Arming.
2. Remove Connector Position Assurance (CPA), then disconnect sensor electrical connectors.
3. Remove sensor attaching bolts, then the sensor.
4. Reverse procedure to install, noting the following:

a. After completing installation, rearm system as described in Air Bag System Disarming & Arming.
b. Turn ignition key to the On position and verify the AIR BAG or SIR warning lamp flashes seven to nine times, then turns off. If warning lamp

does not operate as specified, refer to System Diagnosis.

Dual Pole Arming Sensor|Page 2126 > < Dual Pole Arming Sensor