Riviera V6-3.8L SC VIN 1 (1995)
Starter Drive/Bendix: Testing and Inspection
Starter Drive Troubles - AC Delco
Starter drive troubles are easy to diagnose and they usually cannot be confused with ordinary starter difficulties. If the starter does not turn over at all
or if it drags, look for trouble in the starter or electrical supply system. Concentrate on the starter drive or ring gear if the starter is noisy, if it turns but
does not engage the engine, or if the starter won't disengage after the engine is started. After the starter is removed, the trouble can usually be located
quickly.
Worn or chipped ring gear or starter pinion are the usual causes of noisy operation. Before replacing either or both of these parts try to find out what
caused the damage. With the Bendix type drive, incomplete engagement of the pinion with the ring gear is a common cause of tooth damage. The
wrong pinion clearance on starter drives of the overrunning clutch type leads to poor meshing of the pinion and ring gear and too rapid tooth wear.
A less common cause of noise with either type of drive is a bent starter armature shaft. When this shaft is bent, the pinion gear alternately binds and
then only partly meshes with the ring gear. Most manufacturers specify a maximum of 0.003 inch radial runout on the armature shaft.
