Riviera V6-3.8L SC VIN 1 (1995)
Stabilizer Link: Service and Repair
Fig. 7 Stabilizer Shaft Replacement
1. Raise and support vehicle, then remove wheels and disconnect Electronic Level Control (ELC) height sensor link at control arm.
2. Remove 2 bolts and position ELC height sensor aside, then remove stabilizer shaft link assembly bolt, nut, retainer and insulators from control arm
, Fig. 7.
3. Remove clamp bolt and bend open end of clamp upward, then remove stabilizer shaft and insulators.
4. Reverse procedure to install, noting the following:
a. Ensure stabilizer shaft is centered before tightening clamp bolt.
b. Tighten all bolts and nuts to specifications.