Riviera V6-3.8L SC VIN 1 (1995)
Wheel Bearing: Service and Repair
Rear
REAR HUB AND/OR BEARINGS
Fig. 2 Hub & Bearing Replacement
1. Raise and support vehicle, then remove wheel and disc brake caliper. It is not necessary to disconnect hydraulic line from caliper; support
caliper assembly from frame to prevent hydraulic line damage.
1. Remove brake rotor and ABS sensor wire connector.
3. Remove 4 bolts, then lift hub and bearing assembly and brake shield from control arm, Fig. 2.
4. Reverse procedure to install. Tighten bolts and wheel lug nuts to specifications.
