Riviera V6-3.8L SC VIN 1 (1995)
Window Regulator: Service and Repair
Door Module Assembly
DOOR MODULE ASSEMBLY
Door Module Removal
Door Module Assembly
REMOVE OR DISCONNECT
1. Trim panel and water deflector. Refer to "Door Trim Panel" and "Water Deflector".
2. Inner belt strip.
3. Window retaining bolts.
4. Door glass. Refer to procedure in this section.
5. Drill out eight rivets on module belt member using 17/64 inch drill.
IMPORTANT: Remove any pieces of rivet that fall in the door. If left in door, these pieces could cause rattles.
6. Window motor electrical connector.
7. Mark all adjustments for future glass adjustment, B, C, D, and E.
8. Loosen adjustments C and B.
9. Lower rear adjustment bracket E and D.
10. Module assembly by pulling up on module belt member.