Riviera V6-3.8L SC VIN 1 (1995)
Wiper Motor: Service and Repair
1. Turn ignition switch to the ACCY position, then set wiper switch to the "PULSE position.
2. Turn ignition switch off when wiper arms are at bottom and not moving.
3. Lift wiper blade assembly up from windshield.
4. Pull out retaining latch with a screwdriver.
5. Pull wiper arm assembly off transmission driveshaft.
6. Disconnect battery ground cable.
7. Disconnect hose from washer hose.
8. Remove five air inlet panel retainers.
9. Push washer hose into firewall.
10. Remove air inlet panel from vehicle.
11. Using wiper transmission separator tool No. J-39232, or equivalent, remove transmission drive link socket from wiper motor crank arm.
12. Pull two harness connector retainers out of wiper motor connector.
13. Disconnect two harness connectors from wiper motor.
14. Remove wiper motor attaching bolts and stud, then the wiper motor from the vehicle.
15. Reverse procedure to install.
