Roadmaster V8-305 5.0L (1992)
4.
Position provided template on frame rail with a 17/64" drill bit inserted into hole in the frame and template. Rotate template so that bottom edge of
template is parallel to the bottom edge of frame rail. Mark/scribe the location of the upper and two sides noted on the template as being the
locating points for the bracket.
5.
Secure and shield fuel lines upward and out of the way of the area where bracket is to be welded.
6.
Position damper bracket onto frame rail and M.I.G. weld bracket to frame using American Welding Society Standard ER70S-6 wire and 75
