Roadmaster V8-350 5.7L VIN P MFI (1995)
CLEAN AND INSPECT
1. Clean gasket sealing surface.
2. Inspect gasket sealing surface for corrosion or damage that would cause a coolant leak. Replace cover assembly or throttle body if necessary.
ASSEMBLE
1. Install new gasket and cover assembly.
2. IAC Valve / coolant cover assembly screws.
Tighten
^
IAC Valve / coolant cover assembly screws to 3.2 Nm (28 lb in.).
3. If installing a new IAC valve, measure distance between pintle and mounting surface. If greater than 28mm, use finger pressure to slowly retract
the pintle.
INSTALL OR CONNECT
1. Install and tighten IAC valve attaching screws
Tighten
^
IAC Valve assembly screws to 3 Nm (27 lb in.).
2. Install throttle body to intake manifold.
3. Negative battery cable.
4. Reset IAC valve pintle position. Refer to ADJUSTMENTS