Roadmaster Estate Wagon V8-350 5.7L (1993)
Starter Motor: Testing and Inspection
Pinion Clearance - Delco-Remy Starters
Fig. 4 Starter Pinion Clearance Test Connections
Fig. 5 Checking Pinion Clearance
There is no provision for adjusting pinion clearance on this type motor. When the shift lever mechanism is correctly assembled, the pinion clearance
should fall within the limits of .010 to .140 inch. When the clearance is not within these limits, it may indicate excessive wear of the solenoid linkage or
shift lever yoke buttons.
Pinion clearance should be checked after the motor has been disassembled and reassembled. To check, disconnect motor field coil connector from
solenoid terminal and insulate end. Connect one battery lead to solenoid switch terminal and the other lead to the solenoid frame, Fig. 4. Using a jumper
lead connected to the solenoid motor terminal, momentarily flash the lead to the solenoid frame. This will shift the pinion into the cranking position until
the battery is disconnected.
After energizing the solenoid with the clutch shifted toward the pinion stop retainer, push the pinion back toward the commutator end as far as
possible to take up any slack movement; then check the clearance with feeler gauge, Fig. 5.