buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Component Diagnostic Charts - PFI|Page 1549 > < Component Diagnostic Charts - PFI|Page 1547
Page 3
background image

C.

A/C pressure control

-

A/C high side pressure above 260 to 310 psi.

-

A/C pressure switch closed to ground.

-

CKT 335 and relay terminal "B" grounded.

    Solenoids and relays are turned "ON" or "OFF" by the ECM internal electronic switches called "drivers". Each driver is part of a group of four called
"Quad-Drivers". Failure of one can damage any other driver within the set.
    Solenoid or relay coil resistance must measure more than 20 ohms. Less resistance will cause early failure of the ECM "DRIVER". Using an
ohmmeter, check the coil resistance of the following before installing a replacement ECM.

a. Fan control relay - pin opposite harness terminals "B" and "C".
b. A/C clutch control relay pins opposite harness terminals "A" and "C".
c. TCC Solenoid

Component Diagnostic Charts - PFI|Page 1549 > < Component Diagnostic Charts - PFI|Page 1547