Skyhawk L4-112 1.8L Turbo VIN J FI (1984)
Front Crankshaft Seal: Service and Repair
Fig. 11 Crankshaft front oil seal installation
1.
Disconnect battery ground cable.
2.
Remove crankshaft sprocket as described under ``Crankshaft Sprocket, Replace.''
3.
Remove key and rear thrust washer from end of crankshaft.
4.
Using a suitable tool, remove crankshaft front oil seal.
5.
During installation of crankshaft front oil seal, position tool No. J-33083 or equivalent, Fig. 11, onto crankshaft. Lubricate front oil seal lip and
install onto crankshaft.
6.
Reverse procedure to complete installation.