Skyhawk L4-112 1.8L Turbo VIN J FI (1984)
Steering Column: Service and Repair
Ignition Lock Cylinder
Fig. 1 Lock cylinder removal
1.
Remove steering wheel as outlined under ``Steering Wheel, Replace'' procedure.
2.
Remove turn signal switch as outlined under ``Turn Signal Switch, Replace'' procedure.
3.
Remove buzzer switch.
4.
Turn lock cylinder to ``Run'' position, then remove the lock cylinder retaining screw and lock cylinder, Fig. 1.
5.
To install, rotate lock cylinder to stop while holding housing. Align cylinder key with keyway in housing, then push cylinder into housing until
fully seated.
6.
Install lock cylinder retaining screw.
7.
Install buzzer switch, turn signal switch and steering wheel.
