Skylark L4-138 2.3L DOHC VIN D MFI QUAD 4 (1989)
Turn Signal Switch: Service and Repair
Fig. 24 Shaft Lock Retaining Ring Removal. 1989-91
Fig. 25 Turn Signal Replacement. 1989-91
1.
Disconnect battery cable, then remove steering wheel and column to instrument panel trim cover.
2.
Remove lock cover, then using a suitable tool, compress lock plate and remove snap ring, Fig. 24.
3.
Remove lock plate, cancelling cam, upper bearing preload spring.
4.
Remove turn signal lever by pulling lever straight out of detent. If equipped with cruise control, use mechanics wire to disconnect electrical
connector and remove harness from column.
5.
Depress hazard warning button, then unscrew button.
6.
Remove turn signal switch wiring protector.
7.
Remove retaining screws and remove switch, Fig. 25. Carefully guide switch wiring up through steering column.
8.
Reverse procedure to install.
