Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Disclaimer
Technical Service Bulletin # 33-17-01A
Date: 971201
Exhaust System - Paint Peeling from Painted Muffler
File In Section: 10 - Body
Bulletin No.: 33-17-01A
Date: December, 1997
Subject:
Paint Peeling from Muffler
(New Repair Paint Available)
Models:
1993-98 Passenger Cars with Painted Mufflers
This bulletin is being revised to add additional model years. Please discard Corporate Bulletin Number 33-17-01 (Section 10 - Body).
Condition
Some owners may experience paint peeling from the muffler.
Correction
Clean and repaint the affected area using the following procedure and product.
Important:
DO NOT REPLACE COMPONENTS TO REPAIR THIS CONDITION.
The exhaust system must be cold to begin this procedure.
Material Required: * Wabash Products # KB-318-HHHS, available in pints or quarts as ready to spray material (no mixing required). Call Wabash
Products, 1-800-326-7269 or 812-232-6097 for pricing and shipping information.
Procedure
On a cold exhaust system:
1.
Raise vehicle on hoist.
2.
While supporting exhaust with a transmission jack, remove the rear exhaust system hangers and lower the exhaust.
3.
Clean the affected area with a wax and grease remover, lacquer thinner or other suitable solvent.
4.
Wire brush the affected area to remove flaking paint and blow off with air.
5.
Sand the affected area with # 80 to 150 grit sandpaper to remove rust, dirt or other contaminants.
6.
Clean the affected area with a wax and grease remover, lacquer thinner or other suitable solvent.
7.
Tape off the rear lower body panels and exhaust pipes forward of mufflers to protect from overspray.
8.
Apply paint to affected area in several (6 to 8) thin coats (to prevent sags and runs) obtaining approximately 1 mil paint coverage.
9.
Raise exhaust system with jack, reinstall exhaust hangers, lower vehicle and remove from hoist.