Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Drive Belt Tensioner: Service and Repair
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the accessory drive belt.
3. Remove the generator assembly. See Starting and Charging.
4. Raise and support the vehicle.
5. Remove the oil filter.
6. Remove accessory drive belt idler pulley.
a. The A/C compressor mounting bolt. See Heating and Air Conditioning.
b. The A/C compressor. Position it aside.
7. Remove the tensioner.
INSTALLATION
1. Install the tensioner. Tighten the tensioner nut to 54 Nm (37 lb ft).
2. Install accessory drive belt idler pulley.
a. The A/C compressor. See Heating and Air Conditioning.
b. The A/C compressor mounting bolts. Tighten the bolts to 54 Nm (40 lb ft).
3. Install the oil filter.
4. Lower the vehicle.
5. Install the generator assembly. See Starting and Charging.
6. Install the drive belt.
7. Connect the negative battery cable.