Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Front Crankshaft Seal: Service and Repair
TOOL REQUIRED
^
J 36010 Front Cover Crankshaft Seal Installer
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the engine front cover.
CAUTION: The engine front cover could be damaged if it is not properly supported during seal removal.
3. Support the front cover and drive the oil seal out the timing chain side of the cover.
INSTALLATION
1. Install the seal into the front cover by driving it in from the timing chain side using crankshaft seal installer. The crankshaft seal installer will
properly position the seal in the front cover,
2. Install the engine front cover.
3. Connect the negative battery cable.