Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Wheels: Service and Repair
On-Vehicle
When needed, on-vehicle balancing will help correct vibrations due to brake drum, rotor, and wheel cover imbalance.
The front suspension should not be allowed to hang free. When the CV joint is run at a very high angle, extra vibrations can occur, resulting in damage
to boots and joints. Always follow the equipment manufacturer's instructions.
When balancing on-vehicle, do not remove the balance weights from the off-vehicle dynamic balance. If more than one ounce of additional weight is
required, it should be split between the inner and outer rim flange.
CAUTION: The driven tire and wheel assemblies should be spun using the engine. Limit speed as stated in the following WARNING.
WARNING: Do not spin the drive wheels faster than 55 km/in (35 mph) as indicated by the speedometer. This limit is necessary because the
speedometer indicates only one-half of the actual wheel speed when one drive wheel is spinning and the other drive wheel is stopped.
Personal injury and damage may result from high speed spinning.