Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Ignition Control Module: Service and Repair
Ignition Control Module Replacement
REMOVE OR DISCONNECT
NOTE: Numbers in text correspond to numbered components in image.
1. Disconnect the negative battery cable.
2. Disconnect the electronic Ignition Control Module (ICM) 11 pin harness connector.
3. Remove the ignition coil and electronic ignition control module assembly to cam housing bolts.
4. Remove the ignition coil and electronic ignition control module assembly from the engine.
5. Remove the housing to cover screws (7).
6. Remove the housing (6) from the cover (1).
7. Remove the coil harness connector (4) from the module (2).
8. Remove the module to cover screws (3).
9. Remove the module (2) from the cover (1).