Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Wheel Cover: Service and Repair
REMOVAL
Remove or disconnect the following:
1. Raise vehicle and suitably support.
2. Tire and wheel assembly.
3. Hub cap.
^
Place a block of wood approximately 50 mm (2 inches) in diameter with a squared off end against the back surface of the cap. A sharp hammer
blow on the block of wood will remove the cap.
INSTALLATION
Install or connect the following:
1. Hub cap.
^
Place cap into position at wheel opening and place a block of wood at least 75 mm (3 inches) on diameter against cap face. Install cap by
striking block of wood with hammer.
CAUTION: Failure to hit cap squarely without the load distributed evenly could result in permanent damage to the cap.
2. Tire and wheel assembly.