Skylark V6-191 3.1L VIN M SFI (1994)
Important:
When using the Stud Mounting Method, the mounting nuts for attaching the inflator module to the vehicle must be removed from the module. J
39401-1 Mounting Nuts (4 required) MUST be used to attach the module to the fixture to ensure sufficient thread engagement. When using the
Flange/Arm Mounting Method, use the J 39401-13 Hold-Down Nuts (4 required) whenever possible. However, if clearance re-strictions do not allow
the use of the J 39401-13 nuts, (4) M6 x 1.0 nuts with washers may be used.
10.
Stretch the SIR Deployment Harness and pigtail adapter from the inflator module to its full length. Refer to Figure 4.
11.
Place a power source near the shorted end of the SIR Deployment Harness. (Recommended application: 12 volts minimum, 2 amps mini-mum. A
vehicle battery is suggested.)