Skylark V6-3100 3.1L VIN M SFI (1996)
7.
Remove upper steering column top cover by disengaging clips. See figure 3.
8.
Remove upper steering column bottom cover (three screws, 7 mm hex-head). See Figure 3.
9.
Remove LH sound insulator fasteners (one nut, two twist retainers). Disconnect courtesy lamp harness. Disengage S.I.R. harness edge clip from
panel.
10.
Remove LH sound insulator to gain access to S.I.R. lower connector (yellow) and redundant radio control (R.R.C.) lower connector.
11.
Remove connector position assurance (CPA) pin from lower S.I.R. connector and disconnect S.I.R. harness.
12.
Disconnect R.R.C. harness lower connector.
13.
Unlock steering wheel and turn as necessary to gain access to air bag module attaching screws. Remove two screws from rear of steering wheel
and disengage air bag module from steering wheel.
14.
Return steering wheel to the centered, straight-ahead position and turn ignition switch to "LOCK" position.
15.
Carefully pull air bag module away from steering wheel and disconnect horn lead ground (black) and the horn lead wire (red).
16.
Remove CPA pin from S.I.R. connector (yellow) and disconnect S.I.R. lead.
17.
Disconnect R.R.C. lead and remove air bag module from steering wheel.
18.
Remove steering wheel nut (21 mm).
19.
Using steering wheel puller J 1859-03 or BT-61-9, remove steering wheel from steering shaft.
