Skylark V6-3100 3.1L VIN M SFI (1996)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Gear Cover
CAUTION: To help avoid personal injury, due to a retained load on the ABS hydraulic modulator, the gear tension relief function of the Tech
1 must be performed prior to removal of the ABS hydraulic modulator/master cylinder assembly. Refer to "Gear Tension Relief Sequence".
NOTICE: Complete overhaul of the hydraulic modulator/master cylinder assembly is not authorized, only the following steps. These steps will break the
unit down into major components for replacement purposes.
GEAR COVER
Hydraulic Modulator/Master Cylinder Assembly
DISASSEMBLE
1. Air cleaner duct clamps and electrical connection.
2. Battery from vehicle.
3. Clip from engine compartment fuse/relay center.
4. Remove air box assembly.
5. Disconnect motor pack electrical connector.
6. Two (2) Torx head screws attaching gear cover.
7. Remove gear cover.
ASSEMBLE
1. Gear cover to hydraulic modulator/master cylinder assembly.
2. Torx head screws attaching gear cover.
TIGHTEN
^
Torx bolts to 4 Nm (36 lb. in.).
3. Connect motor pack electrical connector.
4. Install air box assembly.
5. Clip to engine compartment fuse/relay center.
6. Battery to vehicle.
