Skylark V6-3100 3.1L VIN M SFI (1996)
and rear motors to ensure the pistons are in the upmost position. DO NOT DRIVE THE VEHICLE. If a Tech 1 is not available, remove foot from
brake pedal, start the engine and allow it to run for at least 10 seconds to initialize the ABS; DO NOT DRIVE THE VEHICLE. After 10 seconds,
turn the ignition "OFF". This initialization procedure MUST be repeated 5 times to ensure any trapped air has been dislodged. Now repeat
bleeding procedure starting at Step 1.
19. Road test the vehicle. Make several normal (non ABS) stops from a moderate speed to ensure proper brake system function. Allow adequate
cooling time between stops.